T-CLOCK INSPECTION

T-CLOCK ITEM	WHAT TO CHECK	WHAT TO LOOK FOR	CHECKOFF
Headlamp	Condition	Cracks, reflector, mounting and adjustment system.
	Aim	Height and right/left.
O--OIL
Levels	Engine Oil	Check warm on centerstand, dipstick, sight glass.
	Hypoid Gear Oil	Transmission, read drive, shaft.
	Hydraulic Fluid	Brakes, clutch, reservoir or sight glass.
	Coolant	Reservoir and/or coolant recovery tank - cool only.
	Fuel	Tank or guage.
Leaks	Engine Oil	Gaskets, housings, seals.
	Hypoid Gear	Gaskets, seals, breathers.
	Hydraulic Fluid	Hoses, master cylinders, calipers.
	Coolant	Radiator, hoses, tanks, fittings, pipes.
	Fuel	Lines, fuel taps, carbs.
C--CHASSIS
Frame	Condition	Cracks at gussets, accessory mounts, look for paint lifting.
	Steering Head Bearings	No detent or tight spots through full travel, raise front wheel check for play by pulling/pushing forks.
	Swing Arm Bushings/Bearings	Raise rear wheel, check for play by pushing/pulling swing arm.
Suspension	Forks	Smooth travel, equal air pressure/damping anti-dive settings.	Left	Right
	Shock(s)	Smooth travel, equal pre-load/air pressure/damping settings, linkage moves freely and is lubricated.	Left	Right
Chain or Belt	Tension	Check at tightest point.
	Lubrication	Side plates when hot. Note: Do not lubricate belts.
	Sprockets	Teeth not hooked, securely mounted.
Fasteners	Threaded	Tight, missing bolts, nuts.
	Clips	Broken, missing.
	Cotter Pins	Broken, missing.
K--KICKSTAND
Center stand	Condition	Cracks, bent.
	Retention	Springs in place, tension to hold position.
Side stand	Condition	Cracks, bent, (safety cut-out switch or pad if equipped).
	Retention	Springs in place, tension to hold position.
Back to page 1

Return to Safety Pages